ガイストリッヒのコースと学会

Osteology Workshop 3: Vertical Augmentation of a Major Bony Defect Using a Customisable Ti-Mesh

場所:
ICC Pyrmont Theatre Meeting Room Level 2
日付:
Sunday 21st June 2020
種類:
Hands-on Workshop
演者:
Prof Matteo Chiapasco

Different reconstructive procedures are nowadays available to allow for implant placement in severely atrophic partially or totally edentulous ridges, such as GBR with particulate grafts with resorbable or non-resorbable membranes or autogenous bone block grafts. These procedures are both reliable, but sometimes time-consuming and very technically demanding in terms of adaptation and fixation of the grafts, both particulate or in blocks.

 

Recently, customized, CAD/CAM titanium meshes are available on the market with the aim of offering results similar to those obtained with the traditional reconstructive procedures, whilst also allowing for the relevant simplification of the surgical procedure.

 

The production of these Ti-Meshes is in fact performed on personalized 3-D models obtained by CBCTs of the atrophic area of each patient, allowing an extreme precision and simplification of the adaptation of the mesh to the defect to be reconstructed.

 

The aim of this workshop is to teach all participants how to perform all of the surgical steps of the reconstructive procedure of partially edentulous jaws with customized Ti-Meshes with the aid of both didactic (including detailed slides & procedural videos) and hands-on (using both animal (pig jaw) and synthetic models) sessions.

LEARNING OBJECTIVES

1. How to optimize pre-operative planning of a clinical case in need of reconstruction of an atrophic edentulous ridge with a customized Ti-Mesh;

2. How to optimize incision lines of soft tissues to access the defect;

3. How to choose the grafting materials for guided bone regeneration (GBR) with Ti- meshes;

4. How to harvest bone chips with bone scrapers from intra-oral sites (mandibular ramus; hands-on exercises using an animal (pig jaw) model );

5. How to optimize the combination of autogenous bone chips with bovine bone mineral for GBR (hands-on exercises using a synthetic model simulating an edentulous area of the jaw);

6. How to adapt the preformed Ti-Mesh to the defect and how to stabilize it with titanium screws (hands-on exercises using a synthetic model simulating an edentulous area of the jaw);

7. How to optimize the use of collagen membranes over the Ti- Meshes prior to soft-tissue closure;

8. How to release mucoperiosteal flaps to obtain a water-tight and tension-free suture (hands-on exercises using an animal (pig jaw) model).

> 概要へ戻る